Oram Used Equipment Qualification Sheet

Qualification Sheet

This Qualification Sheet must be A) completed and signed by the person(s) inspecting the mechanical and physical items, and B) maintained in the service file along with the repair invoices.

95 Point Qualification Sheet

Oram Stock #:	__________________________	Model:	__________________________
Chassis Serial #:	__________________________	Year:	__________________________
Hour Meter:	__________________________

	ENGINE
Item #	Replace	Meets Std	Repair/ Replace/ Adjust
1	Tune-up including:	_____	_____
	Distributor cap	_____	_____
	Spark plugs	_____	_____
	Ignition timing	_____	_____
	Rotor	_____	_____
	Engine oil filter	_____	_____
	Oil	_____	_____
	Engine RPM	_____	_____
	Engine valves	_____	_____
	Engine Performance at idle	_____	_____
	Inspect and Adjust
2	Belts	_____	_____
3	Engine motor mount	_____	_____
	Measure
4	Cylinder compression pressure - 80% of factory specification	_____	_____

	MAST
Item #	Inspect, Lubricate and Adjust	Meets Std	Repair/ Replace/ Adjust
5	Mast mountings	_____	_____
6	Tilt mounting	_____	_____
7	Carriage rollers	_____	_____
8	Mast rollers	_____	_____
9	Mast chains	_____	_____
10	Side shifter	_____	_____
11	Fork thickness - 90% of factory specification	_____	_____

	TRANSMISSION
Item #	Drain and Replenish	Meets Std	Repair/ Replace/ Adjust
12	Transmission oil and differential fluid	_____	_____
13	Oil filter	_____	_____
	Lubricate
14	Chassis	_____	_____
	Inspect and Adjust
15	Inching Valve	_____	_____
16	Control Valve	_____	_____
17	Transmission oil and differential leaks	_____	_____
18	Housing for Damage	_____	_____
19	Axle Shaft	_____	_____
20	Transmission oil pressure and stall RPM - 90% factory specification	_____	_____

	FUEL SYSTEM
Item #	Replace	Meets Std	Repair/ Replace/ Adjust
54	Fuel filter	_____	_____
	Inspect
55	For leaks	_____	_____
56	Injection pump timing	_____	_____
57	Carburetor link	_____	_____
58	LPG regulator and vaporizer	_____	_____
59	Water separator	_____	_____

	ELECTRICAL SYSTEM
Item #	Inspect and Adjust	Meets Std	Repair/ Replace/ Adjust
60	Wiring harness for damage	_____	_____
61	Alternator for charging voltage	_____	_____
62	Motors for brush and/or armature wear - 90% of factory specification	_____	_____
63	Fuses	_____	_____
64	Starter motor for condition of pinion gear mesh	_____	_____
65	Vertical and horizontal battery restraint	_____	_____
66	Battery fluid level and specific gravity	_____	_____
67	Engine stop for diesel trucks	_____	_____
68	Pre-heater glow plug for diesel trucks	_____	_____

	STEERING SYSTEM
Item #	Inspect and Adjust	Meets Std	Repair/ Replace/ Adjust
69	Steering knuckle for damage	_____	_____
70	Power steering hoses	_____	_____
71	Power steering cylinder for leaks	_____	_____
72	Steering valve	_____	_____
73	Mounting and linkage	_____	_____
74	Steering wheel for damage or play	_____	_____
75	Wheel baring seals	_____	_____
76	Rear axle	_____	_____
77	King pin, tie rods and drag links	_____	_____
	Clean and Lubricate
78	Grease fittings	_____	_____

	COOLING SYSTEM
Item #	Drain, Flush and Refill	Meets Std	Repair/ Replace/ Adjust
79	Cooling system	_____	_____
	Inspect and Adjust
80	Fan belt	_____	_____
81	Thermostat	_____	_____
82	Radiator mounts	_____	_____
83	Pressure system	_____	_____
	Water pump	_____	_____
	Fan clutch	_____	_____
84	Clean radiator	_____	_____

	BRAKES
Item #	Inspect and Adjust	Meets Std	Repair/ Replace/ Adjust
21	Brake shoe or pad condition	_____	_____
22	Brake shoe return spring	_____	_____
23	Master cylinder and wheel cylinder	_____	_____
24	Brake pipe	_____	_____
25	Anchor pin	_____	_____
26	Automatic adjuster	_____	_____
27	Backing plate	_____	_____
28	Brake reservoir	_____	_____
29	Seat switch (power cut off)	_____	_____
30	Service brake tension play	_____	_____
31	Parking brake and automatic parking brake tension and play	_____	_____
32	Drum and lining clearance	_____	_____
33	Drum wear and damage	_____	_____
34	Engine motor mount	_____	_____

	TIRES AND WHEELS
Item #	Inspect and Adjust	Meets Std	Repair/ Replace/ Adjust
35	Front and rear wheel bearing	_____	_____
36	Lug, wheel and hub nuts	_____	_____
37	Tire inflation pressure	_____	_____
38	Rim, side ring and disc wheel	_____	_____
39	Tires for wear, cuts, damage - 80% of original tread	_____	_____

	HYDRAULIC SYSTEM
Item #	Drain and Replenish	Meets Std	Repair/ Replace/ Adjust
40	Oil filter	_____	_____
41	Oil	_____	_____
42	Clean strainer	_____	_____
	Inspect and Adjust
43	Cylinder operation	_____	_____
44	Cylinder for damage or leaks and mounting	_____	_____
45	Lifting and lowering speed	_____	_____
46	Mast lift and tilt pressure	_____	_____
47	Hydraulic let-down valve	_____	_____
48	Hydraulic piping for fit, routing and play	_____	_____
49	Rod, rod screw and rod end	_____	_____
50	Pin and cylinder bearing	_____	_____
51	Hydraulic oil tank-level and contamination	_____	_____
52	Oil pump	_____	_____
53	Control lever operation	_____	_____

	SAFETY, CHASSIS & ERGONOMICS
Item #	Inspect and Adjust	Meets Std	Repair/ Replace/ Adjust
85	Function of instruments - horn, lights, turn signals, etc.	_____	_____
86	Overhead guard for damage	_____	_____
87	Tighten all frame and OHG bolts	_____	_____
88	Seat belts for damage or play	_____	_____
89	Seats - replace or reupholster if damaged	_____	_____
90	Frame for damage	_____	_____
91	Load backrest extension mounting	_____	_____
92	Warning labels	_____	_____
93	Safety equipment brochure	_____	_____
94	Manuals	_____	_____
95	Paint - steam clean, sand, prime and repaint	_____	_____

USED FORKLIFT MGR FINAL ACCEPTANCE
Required Signature

Service Manager: ___________________________

Used Forklift Mgr: ___________________________

1034 S 8th Street
Kansas City, KS 66105
Phone: (913) 621-4242
Fax: (913) 621-5759

2504 E Livingston
Springfield, MO 65803
Phone: (417) 831-1338
Fax: (417) 831-3513

727 S 8th Street
St. Joseph, MO 64501
Phone: (816) 279-2332
Fax: (816) 279-2182

Close this window